Hi! First time using Talend!
I'm using Open Studio for Data Quality(6.5) to explore Data Profiling Analysis.
My dataset is in a csv, which I imported using the FileDelimited connection.
The single column analysis went really well, however, when I tried to make a Table Analysis (in this case the Business Rule) I was unable to select my dataset. It said that there are no tables selected. Any ideia?
Thanks in advance!
when you do Tables anlysis,you nee to click on "Sletect Tables", as shown in below.
Did it help you?
In this case thank's to mark this case as resolved (Kudos also accepted).
first do not select metadata and expand the Columns and select the Columns then yow will get into right side.
Select Tables>>Expand Metedata>> and select Columns
Can you show the the way how your doing? what was the error?
I imported the csv file as a File Delimeted File. Single Column Analysis is working fine, however, I can't make table analysis.
From the Selection screen shot, uncheck the Enrollments and check only Columns ,then you will get into the right side window and click on OK.
If this help please give kudos when a reply is helpful and click Accept the solution when you think you're good with it.
that is ok,when you checK the Columns it should display all coumns in right side section.
can you share your excel and screenshot of the issue please?
I can't share the Excel It's private information.. But I have the error in the figure. As you can see, I have all the columns in the right selected. I also tried to select only in the right, but I still get the same error..
Watch the recorded webinar!
Create systems and workflow to manage clean data ingestion and data transformation.
Introduction to Talend Open Studio for Data Integration.
Test drive Talend's enterprise products.