Hello, I testing talend esb for my company, i tried to use the debugger and place some break points. The flow doesn't stop execution at break point. According to documentation "In order to be able to run a Job in Debug mode, you need the EPIC module to be installed". I don't know if this stay true and how to do it. Thanks for you help
Hi, Yes I referred to that document. I checked the document that I'v already seen https://community.talend.com/t5/Design-and-Development/Tracing-records-with-breakpoints/ta-p/21694?c.... But I was disappointed by the note "This feature is available only in Talend Enterprise Data Integration (not community edition)." Is that a prerequisite to use this feature of the debugger? In this case, with my Open Studio I can add breakpoints, but It will not help at all Last question is it possible to try the enterprise edition for a limited period ?
This is the version of the Studio I installed: "Talend Open Studio for ESB" Version: 5.4.0 Build id: r110020-20131025-0651
Hi, Due to "Tracing records with breakpoints " is used in conjunction with Talend Administrator Center, so it is only available in Talend Enterprise Subscription Version. Please contact us, send an email to email@example.com for your requirement (trial product of talend enterprise subscription version). Best regards Sabrina
-- Don't forget to give kudos when a reply is helpful and click Accept the solution when you think you're good with it.