Character encoding on AS400

One Star

Character encoding on AS400

Hi forum
I have a problem when I load some characters to AS400.
The symbols are € (euro), ° (degrees) and some others.

When I extract my value from an Excel file I set the encoding to "UTF-8" and if I try to load this values on a file delimited (csv) I can see the original characters.

Then if I load to AS400 I have wrong characters.

I tried to set some parameters on tAS400Output component like "characterEncoding=UTF-8" but it not works.
Have you some suggestions about this behavior?
Regards
Alessandro
 
Moderator

Re: Character encoding on AS400

Hi,
Please take a look at a related forum:http://www.talendforge.org/forum/viewtopic.php?id=6556
Best regards
Sabrina
--
Don't forget to give kudos when a reply is helpful and click Accept the solution when you think you're good with it.
One Star

Re: Character encoding on AS400

More about........What is character encoding
Vyar